# What plant specs did Paraguay's 2023 PSA tender set?

**What PSA plant capacity, purity, backup, acceptance test and room requirements did Paraguay's Ministry of Health set in its World Bank financed 2023 tender for hospital oxygen plants?**

Under Addendum 11 of 15 June 2023 to tender 402407, Paraguay's Ministry of Health asked for a duplex PSA generator of at least 40 Nm³/h at 75 PSI per PSA, oxygen of at least 93%, automatic switchover to backup manifolds below 93%, and a 96 hour acceptance run.

## The tender

Tender 402407, an international competitive tender run by the Ministry of Public Health and Social Welfare through its World Bank project unit, asked for PSA medical oxygen plants for five hospital lots. The DNCP portal page shows the tender published on 1 November 2022, a final bid date of 4 July 2023 and the state "Adjudicada" (awarded) when read on 19 November 2026. The requirements below are this one buyer's, taken from its addenda and from the replies it gave to bidders, and they are not a Paraguayan rule.

## Capacity and purity

Addendum No. 11 describes a duplex PSA generator of 40 Nm³/h at 75 PSI for each PSA, as a minimum. The Ministry's reply to a bidder says each lot asked for two plants of at least 40 Nm³/h. The electronic item list had described the oxygen as 96% ± 3%; a bidder asked for a correction, and the reply was that the equipment must reach a minimum of 93%, as set in Addendum No. 11. That addendum also replaced the specification wording "93% ± 3%" with "at least 93%".

## Backup, control and acceptance

- The control panel was to cut the PSA supply and send the oxygen stored in the backup manifolds when purity fell below 93%, when pressure fell below the set minimum, or when a high carbon monoxide level was registered.
- The plant was to run automatically without supervision, with on-site alarms and maintenance reminders.
- Delivery was tied to a 96 hour continuous run at full capacity, checking production, oxygen concentration, automatic stop and start, valves and alarms.
- A mass flowmeter with instantaneous reading and totaliser was to be sized for the maximum flow of the two PSA.
- Electrical supply followed the national utility's supply, with an online UPS for the control panel; the available current was stated as 380/3/50 Hz.
- The PSA exhaust was to be outside the machine room, with outdoor ducts.

## Room and air treatment

In reply to a bidder, the project unit said the PSA plant was to be installed in a room built by the bidder only for that purpose, and that plants installed in containers were not accepted. Addendum No. 11 also asked for a concrete base, a roof and a fenced enclosure with access gates for the plant and the emergency generator. For the air dryer it asked for a refrigerant type designed for ambient temperature up to 50 °C and inlet air up to 50 °C, or else sizing with the manufacturer's correction factor, with the correction table included in the bid. Asked about the air compressor, the project unit pointed to folio 82 of the tender document, which it described as an air-cooled, oil-free rotary screw compressor.

The five lots were hospitals, including a paediatric hospital, a maternal and child hospital and a regional hospital. For how a buyer's specification is usually built, see [what a PSA tender specification should include](https://library.ultracontrolo.com/answers/what-should-a-psa-tender-specification-include/), and for the backup side see what backup a hospital should keep with a PSA plant.

### Did the tender accept containerised plants?

In its reply to bidders, the project unit said the plant was to be installed in a room built by the bidder for that purpose and that plants installed in containers were not accepted.

### Was the bid deadline still open?

The DNCP page gives 4 July 2023 as the final bid date, so it has passed, and it lists the tender as awarded.

## Sources

- [DNCP, tender page ID 402407, Ministry of Public Health and Social Welfare, international competitive tender 02/2022 (read 19 November 2026)](https://www.contrataciones.gov.py/licitaciones/convocatoria/402407-provision-e-instalacion-puesta-marcha-plantas-generadoras-oxigeno-medicinal-tipo-psa-1.html)
- [Project unit, Addendum No. 11 to tender 402407, published 15 June 2023 (document list on the DNCP page, read 19 November 2026)](https://www.contrataciones.gov.py/licitaciones/convocatoria/402407-provision-e-instalacion-puesta-marcha-plantas-generadoras-oxigeno-medicinal-tipo-psa-1/documentos.html)
- [Project unit, Aclaratoria 1 (replies to bidders) to tender 402407, published 15 June 2023 (document list on the DNCP page, read 19 November 2026)](https://www.contrataciones.gov.py/licitaciones/convocatoria/402407-provision-e-instalacion-puesta-marcha-plantas-generadoras-oxigeno-medicinal-tipo-psa-1/documentos.html)
- [DNCP, Consultas Realizadas, tender 402407 (questions and dates, read 19 November 2026)](https://www.contrataciones.gov.py/reporte/convocatoria/402407-provision-e-instalacion-puesta-marcha-plantas-generadoras-oxigeno-medicinal-tipo-psa-1/consultas.pdf)

Reviewed: 2026-11-19. Ultra Controlo engineering. https://library.ultracontrolo.com/answers/what-plant-and-test-requirements-did-paraguays-2023-psa-tender-set/
