# Which condensate drain for a compressor, dryer or receiver?

**Which condensate drain should a compressor, dryer or receiver use?**

The US Department of Energy sourcebook (2016) describes four ways to drain condensate: manual valves, level-operated traps, timed solenoid valves and zero air-loss traps; the Compressed Air Challenge Fact Sheet #11 (May 2026) says automatic traps should never be left partially open and suggests demand-type drain traps where float traps are a maintenance burden.

Traps, sometimes called drains, remove moisture from the compressed air system. The third edition (2016) of the sourcebook says automatic condensate traps conserve energy by preventing the loss of air through open petcocks and valves, and that poorly maintained traps can waste a lot of compressed air.

| Drain type | How it works | What the sourcebook warns |
|---|---|---|
| Manual valve | An operator opens a valve to discharge the condensate | Too often left open on moisture separators, intercoolers, refrigerated dryers and filters, so compressed air escapes continually |
| Level-operated mechanical trap (float or inverted bucket) | The condensate level operates the trap | Float traps do not waste air when working properly but often need a great deal of maintenance and are prone to blockage from sediment; inverted bucket traps may need less maintenance but waste air if there is too little condensate to keep their prime |
| Electrically operated solenoid valve | A timer opens the valve for a set time at preset adjustable intervals | The valve may not stay open long enough to drain the condensate, and it opens even when little or no condensate is present, losing compressed air |
| Zero air-loss trap with reservoir | A float or level sensor operates a solenoid or ball valve that keeps the condensate in the reservoir below the high-level point; in another type, a float sends a pneumatic signal that opens a ball valve | Drain and clean the reservoir often, so contaminants do not foul the mechanism |

The sourcebook adds that level-operated traps and solenoid valves should have strainers installed to reduce contaminants, that the potential for freezing must be considered, with heated drains where necessary, and that leaving a manual drain valve cracked open should not be tolerated because it wastes costly compressed air.

## What the 2026 fact sheet adds

The Compressed Air Challenge Fact Sheet #11 (May 2026) says that leaving automatic condensate traps partially open for constant draining wastes substantial energy and should never be done. If a float-operated automatic drain is not working properly, it should be cleaned and repaired instead of left open, and if maintaining float-operated traps is a burden, the fact sheet suggests replacing them with more reliable demand-type drain traps.

## Compressor, dryer, receiver, filter

The 2016 sourcebook says a moisture separator is generally installed after each intercooler or aftercooler, that an air receiver after a reciprocating compressor can collect condensate, and that filters should be installed with efficient condensate drains. In Gardner Denver's filter brochure, the G and H grade filters and the water separators have an internal float drain, while the particulate (P) and activated carbon (V) grades have a manual unloader.

## Where the condensate goes

The 2016 sourcebook says contaminated condensate requires removal of lubricant before it is discharged to a sewer system, recommends consulting the local sewage authority for allowable contamination levels, and says condensate treatment should meet local codes. The 2026 fact sheet says it is no longer acceptable to discharge condensate to sewer lines without treatment to remove contaminants such as entrained lubricants, except condensate from some lubricant-free compressor systems.

The ULTRASEC datasheet lists, among the controls of the ULTRASEC refrigeration dryer, a digital temperature indicator and an electronically controlled condensate drain.

### Can a drain valve be left slightly open?

No: the US Department of Energy sourcebook (2016) says a manual drain valve left cracked open should not be tolerated, and the Compressed Air Challenge Fact Sheet #11 (May 2026) says automatic traps should never be left partially open, because both waste compressed air.

### Do condensate drains need frost protection?

The US Department of Energy sourcebook (2016) says the potential for freezing must be considered and heated drains provided where necessary.

## Sources

- [US Department of Energy and Compressed Air Challenge, Improving Compressed Air System Performance: A Sourcebook for Industry, third edition (2016)](https://www.energy.gov/sites/prod/files/2016/03/f30/Improving%20Compressed%20Air%20Sourcebook%20version%203.pdf)
- [Compressed Air Challenge, Compressed Air Systems Fact Sheet #11: Proven Opportunities at the Component Level (May 2026, Rev. 01)](https://www.compressedairchallenge.org/data/sites/1/media/library/factsheets2026/fact-sheet-11-proven-opportunities-at-the-component-level_updated2026.pdf)
- [Gardner Denver, High efficiency compressed air filtration & water separation, GDF Series & GDWS Range (brochure G8 07.EN.04/26.CI)](https://azure-na-assets.contentstack.com/v3/assets/blt87a221679f131e8d/bltd9e70b6889b7a1db/69f8ab12162b3af388c7cd71/25370_GD_Filter_brochure_updates_EN_work.pdf)
- [ULTRASEC datasheet, p. 2](https://www.ultracontrolo.com/products/ultrasec)

Reviewed: 2026-11-19. Ultra Controlo engineering. https://library.ultracontrolo.com/answers/which-condensate-drain-for-compressed-air/
