Industry
Maintenance of industrial compressed air systems
What maintenance does an industrial compressed air system need to keep its performance?
Under the Compressed Air Challenge's Fact Sheet #5 (May 2026, Rev. 1), industrial compressed air systems require periodic maintenance to operate at peak efficiency and minimise unscheduled downtime, and all equipment in the system should be maintained in accordance with the manufacturers' specifications.
What inadequate maintenance causes
The fact sheet says inadequate maintenance can have a significant impact on energy consumption through lower compression efficiency, air leakage or pressure variability, and can lead to high operating temperatures, poor moisture control and excessive contamination.
Basic checklist by component
| Component | What the fact sheet lists |
|---|---|
| Inlet filter cartridges | Inspect and clean or replace per manufacturer specifications; dirty filters increase energy consumption |
| Drain traps | Clean out debris and check operation periodically; a trap stuck open leaks compressed air, and one stuck closed lets condensate back up and carry downstream |
| Compressor lubricant | Inspect the level daily and top off or replace per manufacturer specifications, and change the lubricant filter per the same specifications |
| Belts | Check for wear and check and adjust tension per manufacturer specifications |
| Water cooling system | For water-cooled systems, check water quality, flow and temperature |
| Leaks | Check lines, joints, fittings, valves, hoses, regulators, filters and end-use equipment |
| Compressor motor | The two most important aspects are lubrication and cleaning |
Benchmarking and responsibility
The fact sheet suggests benchmarking the system by tracking power, pressure and flow: if power use at a given pressure and flow goes up, the efficiency of the system is degrading. It says one person should be given responsibility for ensuring that all maintenance is performed properly, on schedule and adequately documented.
Ultra Controlo
The ULTRACECO ESW datasheet states that the first maintenance is only at 10,000 hours. UltraCare covers preventive maintenance, corrective service, original spare parts and emergency support, and the Industrial 2026 catalogue names Gardner Denver, Elmo Rietschle, Thomas, Speck Pumpen and Speck Triplex as partner brands that Ultra Controlo distributes and services. For leaks and energy see compressed air leaks and energy savings.
More questions
Should maintenance be more frequent than the manufacturer's intervals?
The fact sheet says that in many cases it makes sense, from efficiency and economic standpoints, to maintain equipment more frequently than the intervals recommended by manufacturers, which it says are primarily designed to protect equipment.
Sources
- Compressed Air Challenge, Compressed Air Systems Fact Sheet #5: Maintenance of Compressed Air Systems for Peak Performance (May 2026, Rev. 1)
- ULTRACECO ESW datasheet, p. 3
- Ultra Controlo, Industrial 2026 catalogue, p. 22 (UltraCare)
- Ultra Controlo, Industrial 2026 catalogue, p. 10 (partner brands)
- Ultra Controlo, UltraCare technical assistance centre
Ultra Controlo figures come from its technical datasheets. Third-party facts were read at the source on the date shown.