Industry
Pumps and blowers for wastewater treatment plants
A 2010 US EPA report on energy conservation at wastewater treatment facilities says pumping and aeration are typically the largest energy users: pumps lift and convey wastewater, solids and treated effluent through the plant and the collection system, and blowers, essentially low pressure, high volume air compressors, supply the aeration air.
Where the pumps are
The EPA report (EPA 832-R-10-005, September 2010) says pumping operations can be a significant energy draw at wastewater treatment plants, in many cases second only to aeration. At the plant headworks, pumps may provide hydraulic head for the treatment processes; within the plant they recycle and convey waste flows, solids and treated effluent; and in remote locations in the collection system they help convey wastewater to the plant.
A Pennsylvania Department of Environmental Protection operator training module on collection systems (revised 2020) describes two common pumping station types. In a wet well/dry well station, the pumps, motors, electrical controls and auxiliary equipment sit in a dry well separated from the wet well; it is typically used for high flows because it has a higher initial cost than a submersible station. A submersible station has submersible pumps placed in the wet well and is typically used for low flows and high heads. The module names centrifugal pumps as the most common type in wastewater pumping stations, and says positive displacement pumps are typically used at treatment plants and are uncommon in pumping stations.
Pump efficiency
The EPA report defines the overall, wire-to-water efficiency of a pumping system as the product of the efficiency of the pump, the motor and the drive or flow control method, and notes that pumps sized for infrequent or future peak flows operate most of the time at a reduced flow below their best efficiency point. It says pumps should be tested every two to three years for flow, head and power consumption, with a more detailed evaluation when overall efficiency is below 60 or 70 percent for centrifugal wastewater pumps. Variable frequency drives are, in its words, the most flexible and efficient means to control flow and are commonly applied to pumps with a large daily flow variation, such as at wastewater pumping stations, but may not be effective where a large static head must be overcome.
Blowers
For aeration, the report describes blowers as essentially low pressure, high volume air compressors, commonly positive displacement or centrifugal. It says the aeration process can account for the largest energy demand of any operation at the facility, and that energy savings can be gained by designing and operating aeration to match, as closely as possible, the actual oxygen demand of the process. Blower types are compared in blowers for wastewater aeration.
Aeration air in Portugal
For aeration air, the Ultra Controlo website says it distributes and services Elmo Rietschle in Portugal; Elmo Rietschle lists aeration and ventilation of water tanks and process aeration among the uses of its side channel blowers.
More questions
Which pump type is most common in wastewater pumping stations?
A 2020 Pennsylvania DEP operator training module names centrifugal pumps as the most common type of pump found in wastewater pumping stations.
How often should wastewater pumps be tested?
The 2010 US EPA report says pumps should be tested every two to three years for flow, head and power consumption, to ensure that they are operating efficiently.
Sources
- US EPA, Evaluation of Energy Conservation Measures for Wastewater Treatment Facilities, EPA 832-R-10-005 (September 2010), chapters 1, 3 and 4
- Pennsylvania Department of Environmental Protection, Wastewater Treatment Plant Operator Certification Training, Module 24: Wastewater Collection Systems Part II (revised 2020)
- Elmo Rietschle, Side Channel Blowers
- Ultra Controlo, Industrial partner brands (website)
Ultra Controlo figures come from its technical datasheets. Third-party facts were read at the source on the date shown.