Industry
What is compressed air storage used for in a plant?
What is air storage used for in an industrial compressed air system?
Short answer
Compressed Air Challenge Fact Sheet #6 (May 2026) says storage can be used to control demand events, the peak demand periods in a compressed air system, by reducing both the amount of pressure drop and the rate of decay, and to protect critical pressure applications from other events in the system.
The three Compressed Air Challenge fact sheets read for this page describe storage as part of how a plant controls pressure. None of them gives a receiver volume or a sizing rule, so this page gives none.
Demand events and critical applications
Fact Sheet #6 (pages 4 and 5) says storage can control demand events and protect critical pressure applications, and can control the rate of pressure drop in demand while supporting the speed of transmission response from supply. Fact Sheet #3 (page 2) says a facility with short periods of heavy demand may benefit from implementing storage options, and that in some cases dedicated storage or differential reduction on critical applications allows a reduction in overall system pressure.
Storage with controls and a flow controller
Fact Sheet #6 (page 4) says that with a flow controller, which separates the supply side of a compressor system from the demand side, storage sized to meet anticipated fluctuations in demand is an essential part of the strategy. The stated goal is to operate demand at the lowest possible pressure, support transient events as much as possible with stored air, and take as long as possible to replenish storage. For some systems a form of refill control, such as a flow control valve, is important (page 5).
Storage and a lower system pressure
Fact Sheet #4 (page 3) says a reduced system operating pressure may require modifications to pressure regulators, filters, and the size and location of the compressed air storage. Fact Sheet #6 (page 1) says that with careful matching of system controls and storage capacity, large sudden changes in demand need not drop the pressure below the minimum requirements.
Storage and the compressors
Fact Sheet #6 (page 5) says many systems have a compressor operating in modulation to support demand events, and that strategic storage solutions can sometimes allow that compressor to be turned off.
Storage in an audit
Fact Sheet #3 (page 3) says an audit evaluates the receiver tank for location and size, and examines the receiver drain trap to see whether it is operating properly. See what a compressed air system audit involves.
More questions
Does a fact sheet give the size of the air receiver?
No. Fact Sheet #6 says storage should be sized to meet anticipated fluctuations in demand, and Fact Sheets #3, #4 and #6 give no volume or formula.
Can storage let a compressor be switched off?
Fact Sheet #6 says strategic storage can sometimes allow a compressor that operates in modulation to support demand events to be turned off.
Sources
- Compressed Air Challenge, Fact Sheet #6: Compressed Air System Controls (May 2026, Rev. 1), pp. 1, 4 and 5
- Compressed Air Challenge, Fact Sheet #4: Pressure Drop and Controlling System Pressure (May 2026, Rev. 1), p. 3
- Compressed Air Challenge, Fact Sheet #3: Compressed Air System Audits (May 2026, Rev. 1), pp. 2 and 3
Ultra Controlo figures come from its technical datasheets. Third-party facts were read at the source on the date shown.
Related
- AnswersHow are several air compressors controlled together?
- GlossaryFlow controller (compressed air)
- AnswersWhy does pressure drop in compressed air cost energy?
- AnswersWhat does a compressed air system audit involve?
- GlossaryArtificial demand (compressed air)
- ComparisonsVariable speed vs fixed speed compressors