Medical air
Coalescing filter vs activated carbon filter in compressed air
Short answer
Compressed Air Challenge Fact Sheet #11 (May 2026) says coalescing filters remove lubricant and moisture, while adsorbent filters handle vaporous contaminants; it recommends a coalescing-type filter before a desiccant-type dryer to prevent fouling of the desiccant bed.
The two filters do different jobs, and compressed air treatment chains normally place them in sequence. The table sets out what two published sources say each one removes.
| Filter | What it removes | Source |
|---|---|---|
| Coalescing filter | Lubricant and moisture; solid particles and water and oil aerosols | Compressed Air Challenge Fact Sheet #11 (May 2026); ACSS ET 08/2010 (Portugal) |
| Activated carbon (adsorbent) filter | Vaporous contaminants; hydrocarbon (oil) vapours and odours, by adsorption | Compressed Air Challenge Fact Sheet #11 (May 2026); ACSS ET 08/2010 (Portugal) |
Why both are used
Fact Sheet #11 recommends a coalescing-type filter before a desiccant-type dryer to prevent fouling of the desiccant bed, and a particulate filter after it to remove desiccant fines. It also says that filtration only to the level required by each application will minimise pressure drop and energy consumption.
In Portugal, the ACSS specification ET 08/2010 (V.2025) for technical compressed air in hospitals describes a chain downstream of the wet receiver: a coalescing filter immediately before each dryer, typically filtering particles down to 1 µm; a high-efficiency coalescing filter after the dryer and dry receiver; and an activated carbon filter. It adds that an activated carbon filter at the end of the line is always an option that should be considered. This is a national hospital specification for non-medical air, not a general rule.
In Ultra Controlo datasheets
The ULTRAMED datasheet lists a high efficiency coalescing filter as the first stage, for water, oil and aerosols removal and particulate above 0.01 µ, followed by a high efficiency activated carbon filter that reduces oil vapour and odours down to 0.003 mg/m³. The air quality table of the same datasheet lists oil separately, below 0.01 mg/m³.
The ULTRAK datasheet describes activated carbon towers that separate oil vapours from compressed air by adsorption. It states that a coalescing filter is required upstream and recommends a 1 µm dust filter downstream. It lists a nominal residual oil vapour content below 0.003 mg/m³, a quality class for oils of 0/1 under ISO 8573-1, and a pressure drop of 20 mbar when new and dry.
More questions
Can a coalescing filter remove oil vapour?
Fact Sheet #11 lists coalescing filters for lubricant and moisture and adsorbent filters for vaporous contaminants; ACSS ET 08/2010 assigns hydrocarbon vapour removal by adsorption to the activated carbon filter.
Which filter goes first?
The ULTRAK datasheet requires a coalescing filter upstream of its carbon towers, and Fact Sheet #11 recommends a coalescing-type filter before a desiccant-type dryer.
Sources
- Compressed Air Challenge, Compressed Air Systems Fact Sheet #11: Proven Opportunities at the Component Level (May 2026, Rev. 01), p. F11-4
- ACSS ET 08/2010 V.2025, section 4.2.7 (Portugal)
- ULTRAK datasheet, p. 2
- ULTRAMED datasheet, p. 3 and p. 4
Ultra Controlo figures come from its technical datasheets. Third-party facts were read at the source on the date shown.